Problem:
I had a problem cutting Peugeot 207 HU83 key blade with new xhorse dolphin xp005l key cutting machine. Giving Error code 2 probes not detected.
Solution:
The clip key is in the wrong position.
Pay attention to the position of the clip key, not in the bottom groove.
If the key clip is in working position you will fail to cut key (usually get error code 2)
Problem:
My Xhorse Dolphin XP008 manual key cutter cannot cut this type of blade. Any solution?
Solution:
Dolphin XP-008 is automatically tightened by this spring, the key blank is too thick and cut too hard.
Losen these two screws then tighten them again.
Try to cut key again.
If it does not work, remove this part and check if belt is loose.
Problem:
I have a problem with my Xhorse Condor xc-mini plus key cutting machine. It won’t cut key, giving me error “Learn Failed 12 Probe Detected”. How to fix it?
Solution:
There is a short circuit, open the LED lampshade to clean up the iron filings.
Disassemble the probe base, follow Step 4-Step 6 here to clean up this part, and check whether the wiring harness is damaged.
