Xhorse Dolphin XP005L HU101 Recommend to Use 1.5mm Cutter?

 Problem:

I try and cut a HU101 blade with Xhorse Dolphin XP005L. It asks to use 1.5mm cutter tho it cuts it perfectly with a 2.5mm cutter. Then I put a 1.5mm cutter in and it instantly Broke it in half. Any clue?

Solution:

Usually 2.5mm cutter works fine on HU101 blade.  But not always work with 2.5mm depending on the key bitting if you have a deeper cut between 2 low cuts you see why the machine recommends the 1.5mm cutter.

If you break a cutter, you need to calibrate the cutter and let machine know you have changed sizes or it will break.  When you change cutter you have to calibrate it again.

1mm diference machine doesn’t know about.

 

www.vvdishop.com