How to Solve Xhorse Dolphin XP007 Cannot Adjust Clamp?

 Problem:

The clamp that comes standard on the Xhorse Dolphin XP007 doesn’t work when you try to make micro-adjustments to the screws above the laterality numbers, such as 1 and 2, and the depth numbers 3 and 4. It doesn’t make the micro-adjustments, leaving the key copies defective. It’s impossible to get them adjusted.

Solution:

1. Install two identical probes

2. Install the same blank HON66

3. Adjust the left and right 1 and 2. You need to loosen both 1 and 2 first

4. If the indicator is not turn on, tighten the top screw on that side

Then try again.

Xhorse Dolphin II Version Unchanged After Update via App?

 Problem:

I’ve updated the Xhorse Dolphin XP005L firmware via Xhorse app, but the version remains unchanged in the device after the upgrade. Any solution?

Solution:

Open the bottom cover of the Dolphin II, check the green connector (image below), disconnect it, and proceed with the upgrade again.

Once the upgrade is complete, reconnect the connector.