Xhorse Dolphin XP005 Battery Not Charging to Full Solution

 Problem:

A user reported that the Xhorse Dolphin XP005 would not fully charge after being left on charge overnight. The battery only reached 3 bars and dropped to 2 bars immediately after powering on.

 

According to VVDISHOP engineers, this is usually related to the battery’s protection mechanism. First discharge the battery further, then charge it continuously without unplugging it.

Solution

1. Use the Dolphin XP005 until the battery level is lower.
2. Connect the charger and leave it plugged in continuously without disconnecting it during the charging process.
3. Check whether the battery can reach full capacity after charging.
4. If the battery still only reaches about 50% after 12 hours of charging, this is not normal. Disassemble the unit and measure the battery to inspect its condition.
5. If the issue persists after these checks, contact your dealer or Xhorse technical support for further assistance.

 

www.vvdishop.com

Replace Resistor on Xhorse Dolphin Battery BMS Board

If your Xhorse Dolphin XP005/XP005L key cutting machine failed to charge the battery, or Bluetooth connection disconnected during key cutting procedure, first of all do a battery test.

 

When checking the battery information, both the battery cells and the BMS (Battery Management System) board appear to be functioning properly. This suggests the issue may be related to the resistor on the green BMS board.

Disassemble the battery module and remove the green BMS board.

Replace the 5mΩ battery sampling resistor shown in the picture below with a 2512 package 2mΩ resistor (1W power rating).

Then try again.

Does Xhorse Condor XC-TWINS Cut Ultion Dumple Keys?

 Can anyone tell me if the Xhorse XCMT01GL Condor XC-TWINS can duplicate the Ultion dimple keys?

Yes, the Xhorse Condor XC-TWINS can duplicate Ultion household keys, but achieving a working key requires careful attention to the specific Ultion key series and blank selection.

Because Ultion keys feature a combination of dimple cuts, side-track milling, and highly specific blank profiles, using the machine’s advanced features correctly is essential to guarantee success.

Xhorse XC-TWINS has AI Optical Recognition function; you can easily recognize key type and cut key.