Hey everybody, I am here and ready to cut a HU58 key for a 1996 BMW 3 series lock. I will use the Xhorse Dolphin XP005 key cutting machine controlled by VVDI Key Tool Max to complete.
I have decoded the key bitting that A track is 23312, B track is 3441, and the lock number is BH130746. So let’s go ahead to xhorse app.
Cut by bitting >> HU58 >> Silca – HU58
It is said to use A clamp, press “OK” to continue.
Input the bitting code on 2 tracks.
Install the key flat on A clamp, fix and fasten it.
Press on Key Tool Max: Cutting key >> Continue
The Dolphin XP-005 starts cutting key…
First side cutting has finished, get all the scraps off there then flip it over. Install the key again to lock it flat.
Go back to Key Tool Max: Cutting key >> Continue
The Dolphin XP005 starts cutting the other side…
All right! Two sides cutting were done! Brush the scraps off, take out the key to have a test. It works perfectly!
Job has done!
This is BMW HU58 key cutting using a Xhorse VVDI Key Tool Max to run the Dolphin XP005 machine.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.