7/28/2021

How to Test Xhorse Dolphin XP005 Battery?

 Here is a little guide to test battery storage of Xhorse Dolphin XP005 key cutting machine. (attention: please recharge it for one hour or more )

 

1.Remove  4 Screw two side of base, then remove base armrest

test-xhorse-dolphin-battery-1

2.Put Dolphin XP-005 on it’s one side, remove the screw marked on picture, remove base

test-xhorse-dolphin-battery-2

3. Remove the screw and unplug 3 connector, remember it original place (better take photo before unplug it), when you install need plug it as original

test-xhorse-dolphin-battery-3

4. Remove battery, Short-circuit the two pins of the start switch, and use a multimeter to measure the two pins of the output terminal. If there is no 24V voltage output, the battery does not store electricity and needs to be replaced

test-xhorse-dolphin-battery-4

You can follow this way when you need to place a new battery for Dolphin as well.

Read also: How to Replace Xhorse Dolphin XP005 Battery?

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.