Xhorse Dolphin XP005 “Error 56" Solution

 Problem

I have successfully cut 3 keys via Xhorse Dolphin XP005 + VVDI Key Tool Max until the 4^th key, it prompted “Error:56. The cutter is short-circuited, please check the cutter conductivity. Please take photo and send to technical support.”

 

The error still exits even if I use other devices to control Dolphin XP005, it occasionally occurs cutter detected error code: 6 as below

“Please do following steps

1. check the clamp is correct;
2. Check height level adjustment finished;
3. Check clamp calibration finished;
4. Check the key insert properly, no chips.”

 

I can’t use Dolphin XP005 machine anymore, I can’ do calibration or anything else. Please help me.

Solution

1. Just take apart the LED lamp cover to brush the scrap iron;
2. Do a electrical conductivity measurement after cleaning, take a video to VVDIshop engineer for help.

How to do electrical conductivity measurement for Dolphin XP005?

http://blog.vvdishop.com/xhorse-dolphin-xp005-electrical-conductivity-measurement/

 

Hope it helps.