Install cutter and probe on Xhorse Dolphin XP005:
Installation steps:
- Put the cutter into the cutter mounting hole and push the cutter to the limit. Then drop the cutter 2-5mm down. When the screw is perpendicular to the notched part of the side of the milling cutter, the locking screw and the fixed milling cutter.
- 2) Push the probe into the probe mounting hole and the tip of probe need to be higher than the tip of cutter .Turn the ‘probe locking screw’ clockwise until the probe is locked.
Uninstallation steps:
1) Unscrew the locks for cutter and probe counter-clockwise until they are loosened off.
2) Take the cutter or probe off when it is loose.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.